Engine Room Description
Fire resistance meets SOLAS B-15 requirements.
Propeller area sound insulated.
Engine room internally sound insulated.
Drip trays under engine and generator are connected to electric waste oil drain pump.
New alternator (2018)
New starter motor in spares
New exhaust elbows
New salt water pump
1 X Marine diesel engine, Perkins Sabre M300Ti 6 cylinder, output 221 kW at 2500 rpm. (completely rebuilt in 2016, new engine mounts) Marine gear 2.5:1 gearbox (new 2016).
Flexible couplings between engine and gearbox and flexible mountings.
Propeller & Stern gear
3-blade Hundested variable pitch propeller, diameter 850mm
Drip free shaft seal replaced in 2015
Water lubricated rubber bearings at bracket and stern tube and flexible shaft coupling.
New cutlass bearings (2020)
Halyard wet exhaust with GRP silencers and gas/water seperators.
Silencers have drain taps.
Silencers supported on flexible mountings.
Main Generator: Northern Lights Lugger 33Kw with big PTO. (6.821 hrs June 2021)
Service Generator: Panda 9Kw to 25Kw (new 2020). 53 hrs June 2021
4 X s/s tanks for total 4000 litres, fuel tanks cleaned in 2016
Racor fuel/air separator.
Fuel supply lines have dual Racor fuel filter/water separators. Single Racor fuel filter/water separator on the generator supply line.
1 X 40 litre oil tank.
1 X 40 litre oil waste tank.
The hydraulic system is a Bosch-Rexroth custom designed system to supply all hydraulic functions quietly and smoothly, eliminating any inherent hydraulic noise. The alternative power sources are installed to meet the demands of the sail handling equipment. Central hydraulic system is PLC controlled.
The hydraulic system is defined on a basis of a central power pack supplying regionally located valve groups, thereby achieving minimal weight to power ratio with the effect of using minimum electrical power with maximum hydraulic movement. Each control valve group is situated close to the operating unit, giving a precise control and allows for a quiet and smooth operation, eliminating inherent hydraulic noise and vibration. The system has three different sources of power. Each source will be operated independently of each other.
The sources are obtained from:
1. Generator PTO pump – fully reconditioned in 2016
2. Main engine PTO pump - fully reconditioned in 2016
3. DC powerpack system using two electrically powered hydraulic pumps.
- Anchor windlass
- Lifting keel and lock
- 3x Sanguinetti capstan
- Jib furler
- Anchor swing arm
- Bow thruster plus up/down
- Jib halyard tensioner
- Backstay tensioner
- Main halyard captive winch
- Main sheet captive winch
- Boom vang
- Transom hatch cylinders
- All drum winches
- Tender winch in lazarette
There are two pneumatic compressors with quick acting couplings in lazarette for transom door seal, companionway hatch and washboard.
Maxpower retractable: 430/34, 30 kW
Noise and Vibration
Every effort has been made to minimize noise and vibration
All engines, pumps, fans, exhaust pipes, hydraulic elements and compressors are flexible mounted.
3x stainless steel tanks with combined capacity of 1500 litres
Wilo freshwater circulation pump with pressure tank.
All piping is colour coded.
Additional Reya backup freshwater pump.
Deck-shower in dinghy garage.
2x Jaspi 120 litre hot-water tanks.
Shore supply connection with Idromar active carbon filter.
SE-water pump for fire/anchor-wash, with connection on fore-deck and amidships + fire hoses.
2x 6kg gas bottles in drained locker
1x Spectra Farfallon watermaker producing 400 litres per hour
Condaria climate control system with independent fancoils in each cabin
Forced ventilation in all cabins.
Exhaust ventilators in galley and bathrooms.
Battery boxes have extractor fan to outside.
2x grey water tanks fore and aft
4x Maxi submersible bilge pumps
2x manual Whale Titan bilge pumps
All marine heads Tecma Standard Plus 24V with fresh-water flush
2x Blackwater tanks drained by Gianneschi pumps (new 2016)
- Bauer Dive compressor
- 3 x tanks
- 2 x BCD